Floor

You are here: Modeling > Floor

Floor

The Floor tool includes the following methods of construction of floors:

	Automatically by similar;
	Line by specifying two points;
	Arc by specifying three points;
	Arc by specifying start, center, end points;
	Circle by specifying a center point and radius.

You can combine a few construction modes such as Line by specifying two points, Arc by specifying three points and Arc by the start, center and end points when creating a floor.

Please note that a floor won't be created correctly if its borders are crossed.

Floor parameters:

	Layered material.
	Floor thickness. Can be set if no layered material is specified. If a layered material is specified, the floor thickness is equal to the thickness of the layered material.
	Level. It determines floor level.
	Vertical offset. Determines the vertical offset of floor relatively to the insertion point. A floor is being built downwards from the insertion point.
	Floor angle of reinforcement. The angle of the reinforcement layout in the floor relative to the Ox axis.
	Reinforcement style. Reinforcement style is applied only to the base layer of the layered material.
	Mark. It appears in the schedules. Necessary for insertion into the drawing.

Floor parameters may be modified in the process of construction and editing. Press Enter to fix the parameter values.

All snaps and accurate construction are available for construction of floors.

To edit a floor, use handles.